31006 LCA LCA: INIT signal stuck low while programming All The firmware encountered a problem programming a set of Xilinx LCA's on one of the boards. Unfortunately, this error message does not indicate which board is having the problem. The diagnostic monitor must be watched when the recorder starts up. Some of the first messages printed are "<board> LCA's successfully configured", where <board> is "MPE", "DPE", and "ALE". The board which does not appear in this list is the one having problems. This board should be replaced. If no "LCA's successfully configured" message can be found (make sure you scroll right back, to before the "Task ... starting up ..." messages), the MPE is probably faulty. Replace it first and see if this makes a difference before replacing any other boards. If replacing boards does not help, the backplane may be faulty. Record error message and contact Creo Service LCA's on either MPE, DPE, or ALE are faulty MPE faulty. Backplane faulty ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:34:16 2008 PST